IBM 7199-92X, Инструкция по установке и эксплуатации

Страница: 34 / 82

2. Install the rear end of the slide rails, as shown in Figure 7:
a. From the front of the rack, line up the three pins on the rear of the slide rail
with the three holes in the selected U on the rear of the rack.
b. Push the rails so that the pins go into the holes
1
, and latch down into
place
2
until it latches into place.
Notes:
1) When you install a 2U appliance, be sure to install the slide rails in the
bottom of the 2U area in the rack.
3. Install the front end of the slide rails, as shown in Figure 8 on page 17.
a. Pull the slide rail forward and insert the two pins
1
on the front of the
rail into the two lower holes in the U on the front of the rack.
b. Drop the rail into place until it clicks. Push the front latch
2
in all the
way.
c.
Repeat steps 1 through 3 to install the other rail into the rack. Make sure
that each front latch is fully engaged
L
3
Figure 6. View of the slide rails
Rear Rack
Figure 7. Install the rear end of the slide rails
16
WebSphere DataPower XC10 Appliance: Type 7199-92X: Installation and User's Guide