IBM 6219 - IntelliStation M - Pro, Руководство по техническому обслуживанию аппаратной части

Страница: 31 / 154

Setting the password check jumper (JP1)
The following illustration shows the location of the password check jumper (JP1) on
the system board.
Note: The default setting is enabled (2-3); however, some early system may default
to disable (1-2).
CMOS
clear jumper (JP3)
Boot block
jumper (JP2)
Password check
(JP1) jumper
Complete the following steps to set the password check jumper (JP1):
1. Review “Important safety information” on page iii.
2. Turn off the computer and peripheral devices.
3. Disconnect all external cables and power cords; then, remove the cover. See
“Turning off the computer” on page 14 for instructions.
v
To disable password checking, set JP1 to disable (1-2).
v
To enable password checking, set JP1 to (2-3).
4. Connect the computer to a power source, keyboard, monitor, and mouse.
5. Turn on the computer.
Enabling Broadcom NetXtreme Gigabit Ethernet Boot Agent
The Broadcom NetXtreme Gigabit Ethernet Boot Agent is part of the BIOS code
that comes with your computer. You can enable the Broadcom NetXtreme Gigabit
Ethernet Boot Agent from the Configuration/Setup Utility program. You can use the
Broadcom NetXtreme Gigabit Ethernet Boot Agent to configure the network as a
startable device, and you can customize where the network startup option appears
in your startup sequence.
Complete the following steps to enable Broadcom NetXtreme Gigabit Ethernet Boot
Agent:
1. From the Configuration/Setup Utility main menu, select Devices and I/O Ports
and press Enter.
Configuration
21