IBM 620410U - IntelliStation E - Pro 6204, Руководство пользователя

Страница: 107 / 166

Table 2. Diagnostic error messages (continued)
Code Text message Detection Action
211 Keyboard error No keyboard has been
detected.
1. Verify that the
keyboard cable is
connected.
2. If the problem
remains, replace the
keyboard cable.
If the problem persists,
call for service.
250 System battery is dead
Replace and run SETUP Bit 7 or RTC Status
Register D is set,
indicating the RTP lost
power. Replace the battery. See
“Replacing the battery”
on page 111.
270 Real-time clock error An RTC update cycle
does not occur within the
expected time frame. Reset the correct time
and date.
271 Check date and time
settings RTC time and/or date
values out of range.
662 Configuration Change
Has Occurred A diskette drive has been
added or removed when
in Enhanced POST or
when password is set. Restore the original
hardware, accept the
new configuration in the
IBM Setup Utility
program, or set the
Diskette Drive A: option
correctly.
1762 If Enhanced POST,
Enhanced Security, or
any password is set,
when a hard disk has
been added or removed. Accept the new
configuration in the IBM
Setup Utility program or
correct the hardware
problem.
1780 Hard Disk Error A hard disk failed
diagnostics. Replace the failing hard
disk drive. If the problem
persists, call for service.
1781
1782
1783
1800 PCI/PnP Error! No
hardware interrupt
available Cannot assign interrupt
resource because all are
used. Correct resource
shortage by removing,
disabling, or rearranging
devices.
1801 PCI/PnP Error! Not
enough space available
to shadow ROM Cannot initialize option
ROM because address
space is full.
1802 PCI/PnP Error! Not
enough I/O space
available Cannot assign I/O
resource because all are
used.
1803 PCI/PnP Error! Not
enough memory space
available Cannot assign memory
resource because all
address space is full.
1804 PCI/PnP Error! Not
enough real memory
space available. Cannot assign memory
resource because all
address space is full.
Chapter 6. Solving problems
91