IBM 3745 Series, Руководство по установке и обслуживанию

Страница: 126 / 270

Starting the IBM PC Enhanced Diagnostics Program
To start the program:
1. Shut down and power-off the system.
2. Wait 10 seconds.
3. Insert the IBM Enhanced Diagnostics Diskette into diskette drive A.
4. Power-on the system.
The initial diagnostics menu will be displayed.
Navigating Through the Diagnostic Programs
Use either the mouse or the keyboard to navigate through the Enhanced
Diagnostics program.
¹
Use the cursor movement keys to navigate within the menus.
¹
The Enter key is used to select a menu item.
¹
The Esc key is used to back up to the previous menu.
¹
For online help select F1.
Running diagnostic tests
There are four ways to run the diagnostic tests:
1. Using the cursor movement keys, highlight Run Normal Test or Run Quick
Test from the Diagnostics Menu and then press Enter.
This will automatically run a pre-defined group of tests from each test category.
Run Normal Test runs a more extensive set of tests than does Run Quick
Test and takes longer to execute.
2. Press F5 to automatically run all selected tests in all categories. See “Test
Selection.”
3. From within a test category, press Ctrl-Enter to automatically run only the
selected tests in that category. See “Test Selection.”
4. Using the cursor movement keys, highlight a single test within a test category
and then press Enter. This will run only that test.
Press Esc at any time to stop the testing process.
Test results, (N/A, PASSED, FAILED, ABORTED), are displayed in the field beside
the test description and in the test log. See “Viewing the Test Log” on page 4-8.
Test Selection
To select one or more tests:
1. Open the corresponding test category.
2. Using the cursor movement keys, highlight the desired test.
3. Press Space bar.
A selected test is marked with a chevron, >>. Pressing the space bar again
de-selects a test and removes the chevron.
4. Repeat steps 2 and 3 above to select all desired tests.
4-4
3745-XXA 4-4 3746-9X0: 6563 SPIM