IBM 3745 Series, Руководство по установке и обслуживанию

Страница: 175 / 270

¹
Do not touch live electrical circuits with the reflective surface of a plastic dental
mirror. The surface is conductive; such touching can cause personal injury and
machine damage.
¹
Do not service the following parts with the power on when they are removed
from their normal operating places in a machine:
– Power supply units
– Pumps
– Blowers and fans
– Motor generators
and similar units. (This practice ensures correct grounding of the units.)
¹
If an electrical accident occurs:
– Use caution; do not become a victim yourself.
– Switch off power.
– Send another person to get medical aid.
¹
Asset ID allows the computer to be scanned by various radio frequency
emitting devices supplied by independent companies. Asset ID is intended for
use only with radio frequency equipment that meets ANSI/IEEE C95.1 1992 RF
Radiation Limits.
Safety Inspection Guide
The intent of this inspection guide is to assist you in identifying potentially unsafe
conditions on these products. Each machine, as it was designed and built, had
required safety items installed to protect users and service personnel from injury.
This guide addresses only those items. However, good judgment should be used
to identify potential safety hazards due to attachment of non-IBM features or
options not covered by this inspection guide.
If any unsafe conditions are present, you must determine how serious the apparent
hazard could be and whether you can continue without first correcting the problem.
Consider these conditions and the safety hazards they present:
¹
Electrical hazards, especially primary power (primary voltage on the frame can
cause serious or fatal electrical shock).
¹
Explosive hazards, such as a damaged CRT face or bulging capacitor
¹
Mechanical hazards, such as loose or missing hardware
The guide consists of a series of steps presented in a checklist. Begin the checks
with the power off, and the power cord disconnected.
Checklist:
1. Check exterior covers for damage (loose, broken, or sharp edges).
2. Power-off the computer. Disconnect the power cord.
3. Check the power cord for:
a. A third-wire ground connector in good condition. Use a meter to measure
third-wire ground continuity for 0.1 ohm or less between the external
ground pin and frame ground.
b. The power cord should be the appropriate type as specified in the parts
listings.
c. Insulation must not be frayed or worn.
4. Remove the cover.
5. Check for any obvious non-IBM alterations. Use good judgment as to the
safety of any non-IBM alterations.
Appendix A. Safety Information
A-3