IBM 3745 Series, Руководство по установке и обслуживанию

Страница: 58 / 270

Step 5 - Customizing Your Service Processor
Notes
1. For any unexpected message or error concerning the service processor:
¹
Go to, “MAP: Entry Point for Problem Isolation” on page 2-1
For any other message or error displayed on the control panel, go to:
¹
The START page of the 3745 Communication Controller Models 210 to
61A Maintenance Information Procedures, SY33-2054, if you are
working on a 3745 Model X1A.
¹
The START page of the 3745 Communication Controller Models 130 to
17A Maintenance Information Procedures, SY33-2070, if you are
working on a 3745 Model 17A.
¹
The START page of the 3746-900 Service Guide, SY33-2116, if you
are working on a 3746-900.
¹
Or go to the START page of the 3746-950 Service Guide, SY33-2108,
if you are working on a 3746-950.
2. The purpose and explanation for the different parameters is given in the
3745 Communication Controller Models A and 3746 Models 900 and 950:
Planning Guide, GA33-0457.
3. Insure that the machine type and model are registered in RETAIN (CCPF).
For U.S.A. machines, please call the Raleigh Multiplexor Support Center
and verify your machine's registration in CCPF for:
a. The seven digit serial number of the 3745/3746 is correct.
b. The three digit model designation for the 3745/3746 is correct.
1. ____ Power ON the display
a. ____ Turn on your display, and adjust the Brightness and Contrast controls
to the approximate midpoint.
You can readjust these controls for personal viewing comfort after you turn
on your service processor.
Note: The locations of the power switch and the Brightness and Contrast
controls on your display might be different from those shown above.
1-34
3745-XXA 1-34 3746-9X0: 6563 SPIM