IBM 3745 Series, Руководство по установке и обслуживанию

Страница: 104 / 270

Keyboard
Note: If a mouse or other pointing device is attached, remove it to see if the error
symptom goes away. If the symptom goes away, the mouse or pointing
device is defective.
001
– Power-off the computer.
– Disconnect the keyboard cable from the system unit.
– Power-on the computer and check the keyboard cable connector on the system
unit for the voltages shown.
All voltages are
±
5%.
Pin
1
2
3
4
5
6
Voltage (Vdc)
+ 5 . 0
Not Used
Ground
+ 5 . 0
+ 5 . 0
Not Used
1
6
2
3 4
5
Figure 3-1. Keyboard Connector Voltages
ARE THE VOLTAGES CORRECT?
Yes No
002
Replace the system board.
003
On keyboards with a detachable cable, replace the cable. If the problem remains
or if the cable is permanently attached to the keyboard, replace the keyboard. If
the problem remains, replace the system board.
Printer
1. Make sure the printer is properly connected and powered on.
2. Run the printer self-test.
If the printer self-test does not run correctly, the problem is in the printer. Refer to
the printer service manual.
If the printer self-test runs correctly, install a wrap plug in the parallel port and run
the diagnostic tests to determine which FRU failed.
If the diagnostic test (with the wrap plug installed) do not detect a failure, replace
the printer cable. If that does not correct the problem, replace the system board or
adapter connected to the printer cable.
3-20
3745-XXA 3-20 3746-9X0: 6563 SPIM