IBM 17351GX, Инструкция по установке и эксплуатации

Страница: 50 / 78

36 Local Console Manager Installation and User’s Guide
To remove a target device from the scan list, complete the following steps:
1. To select a target device to be removed from the scan list, complete one of the following steps:
• In the Scan window, clear the check box next to the target device to be removed.
• Double-click on the target device name or port.
• Press Shift + Delete to remove the selected target device and all entries below it.
• Click the Clear button to remove all target devices from the scan list.
2. Click OK .
To start the scan mode, complete the following steps:
1. Click Commands . The Commands window opens.
Figure 3.13: Commands window
2. Select Scan Enable in the Commands window. Scanning will be begin immediately.
3. Click X to close the Commands window.
To cancel scan mode, complete one of the following steps:
• If the OSCAR interface is open, select a target device.
• If the OSCAR interface is not open, move the mouse or press any key on the keyboard to
stop scanning at the currently selected target device.
Running switching system diagnostics
You can validate the integrity of the switching system through the Run Diagnostics command. This
command checks the main board functional sub-systems (memory, communications, appliance
control, and the video channels) for each system controller. When you select the
Run Diagnostics
button, you will receive a warning that indicates that all users (remote and local) will be
disconnected. Click
OK to confirm and begin the test.