IBM 17351GX, Инструкция по установке и эксплуатации

Страница: 42 / 78

28 Local Console Manager Installation and User’s Guide
all the time, and where the flag is displayed on the desktop. The following table shows examples of
status flags.
To specify the status-flag settings, complete the following steps:
1. Press Print Screen. The Main window opens.
2. Click Setup > Flag .
3. Set one or more of the following settings:
• Select Name or eID to specify the information that is displayed in the flag.
• Select Displayed to display the flag all the time, or select Timed to display the flag for only 5
seconds after you select a target device.
• In the Display Color section, select the flag color.
• Select Opaque to make the flag solid, or select Transparent to make the desktop visible
through the flag.
• To specify the position of the flag, complete the following steps:
a. Click Set Position.
b. Hold down the left mouse button on the title bar of the Set Position window, and drag
the window to the new location.
c. Press the right mouse button to close the Set Position window.
4. Click OK to save the changes, or click X or press Escape to exit without saving the changes.
Setting the keyboard country code
By default, the appliance sends the US keyboard country code to USB cables attached to target
devices and the code is applied to the target devices when they are turned on or rebooted. Codes are
then stored in the CO cable. Using a keyboard code that supports a language different from that of
the appliance firmware will cause incorrect keyboard mapping.
Table 3.4: OSCAR interface status flags
Flag Description
Flag type by name.
Flag indicating that the user has been disconnected from all systems.
Flag type by eID number.
Flag indicating that Broadcast mode is enabled.