IAI ssel, Руководство по эксплуатации

Страница: 483 / 497

457
Appendi
x
(In the panel window, the three digits after “E” indicate an error number.)
Error No. Error name Description, action, etc.
E77 Magnetic-pole sensor installation specification mismatch error The magnetic-sensor installation specification in the system’s axis-specific
parameter and that of the installed encoder do not match.
E78 Brake installation specification mismatch error The brake installation specification in the system’s axis-specific parameter and
that of the installed encoder do not match.
E79 Abnormal response error when sending EEPROM-data setting slave
command An abnormal response was received when an EEPROM-data setting slave
command was sent.
E7A Maximum receive size over error when sending EEPROM-data
setting slave command The receive size exceeded the limit value when an EEPROM-data setting slave
command was sent.
E7B Motor-drive power ON timeout error Abnormal current flow from the motor-drive power source
E7C Register read/write test error Error reading/writing the register
E7D Linear-movement axis parameter error Check axis-specific parameter Nos. 38, 68, 1, etc.
E7E Parameter error The parameter is invalid.
E7F Stroke parameter error Check axis-specific parameter Nos. 7, 8, 1, etc.
E80 Unsupported card error An unsupported card is installed in an I/O slot.
E81 Priority auto-assignment card non-detection error Priority auto-assignment card cannot be detected.
E82 Card mismatch error The combination or positioning of I/O slot cards has a problem.
E83 I/O slot card error The I/O slot card is invalid.
E84 Resolution parameter error Check axis-specific parameter Nos. 47, 50, 51, 44, 42, 43, 1, 37, etc.
E85 Driver ready OFF factor indeterminable error Driver ready OFF factor cannot be determined.
E86 Fieldbus error (FBVCCER) A fieldbus error (FBVCCER) was detected.
E87 Fieldbus error (FBPOWER) A fieldbus error (FBPOWER) was detected.
E88 Power error (Other) A power error (Other) was detected. This error also generates when the power
OFF

ON interval is short. After the power has been turned off, be sure to wait
for at least 5 seconds before turning it back on. Abnormal regenerative resistance
temperature is also suspected.
E89 SCIF open error in non-AUTO mode (Servo in use) In a mode other than AUTO, opening of the serial 1 channel (also used by the PC
software/TP port) from a SEL program is prohibited while the servo is in use (to
ensure safety).
E8A SEL program flash-ROM status error Data is not written to the flash ROM correctly or written in an old, incompatible
application version.
E8B Symbol definition table flash-ROM status error Data is not written to the flash ROM correctly or written in an old, incompatible
application version.
E8C Point data flash-ROM status error Data is not written to the flash ROM correctly or written in an old, incompatible
application version.
E8D Parameter flash-ROM status error Data is not written to the flash ROM correctly or written in an old, incompatible
application version.