IAI ssel, Руководство по эксплуатации

Страница: 480 / 497

454
Appendi
x
(In the panel window, the three digits after “E” indicate an error number.)
Error No. Error name Description, action, etc.
E18 Task ID error The task ID is invalid.
E19 WAIT factor error The WAIT factor is invalid.
E1A WAIT logic error The WAIT logic is invalid.
E1B Point-data valid address error Point-data valid address is not set.
E1C Source data error The source data is invalid.
E1D Unaffected output number error The unaffected output number is invalid. A value other than an output port
number (“0” is acceptable) may be input in I/O parameter Nos. 70 to 73.
E1E Zone parameter error A value other than an output port/global flag number (“0” is acceptable) or
duplicate numbers may be input in axis-specific parameter Nos. 88, 91, 94 and
97, or the output number specified as system output in the I/O parameter for
output function selection may be duplicated, among other reasons.
E1F I/O assignment parameter error A value other than an I/O port number (“-1” is acceptable) or other than an I/O
head port [multiple of 8] may be input in I/O parameter Nos. 2 to 9, or a
value other than a [multiple of 8] may be input in I/O parameter Nos. 14 to 17.
E20 I/O assignment duplication error I/O assignments are duplicated. Check I/O parameter Nos. 2 to 9 and 14 to 17
and the I/O slot card type (number of I/Os), etc.
E21 I/O assignment count over error The I/O assignments exceed the specified range. Check I/O parameter Nos. 2 to
9 and 14 to 17 and the I/O slot card type (number of I/Os).
E22 Header error (Slave communication) The header in the message received from the slave card is invalid.
E23 Card ID error (Slave communication) The card ID in the message received from the slave card is invalid.
E24 Response type error (Slave communication) The response type in the message received from the slave card is invalid.
E25 Command type error (Slave communication) The command type of the transmitting command is invalid.
E26 Target type error The target type is invalid.
E27 No target error Target (driver card, I/O card, encoder or other slave card) is not installed.
E29 EEPROM error (EWEN/EWDS not permitted) EEPROM access error (when writing)
E2A Read compare mismatch error during EEPROM write EEPROM access error (when writing)
E2B Abnormal response error when sending EEPROM information
acquisition command An abnormal response was received when a slave-EEPROM information
acquisition command was sent.
E2C Maximum receive size over error when sending EEPROM
information acquisition command The maximum receive size exceeds the limit value when a slave-EEPROM
information acquisition command is sent.
E2D Receive-data checksum error when sending EEPROM information
acquisition command The checksum of receive data is invalid when a slave-EEPROM information
acquisition command is sent.
E33 Slave response logic error The slave response logic is invalid.
E34 Slave block number out of range The slave block number is out of range.