Powermax125
Service Manual 808070
237
9 – Power Supply Component Replacement
5.
Push the threaded end of the new work lead receptacle into the opening in the front panel, with the keyway facing up,
until fully seated. (See
.)
6.
Place the lock washer over the work lead receptacle inside the power supply.
7.
Tighten the nut onto the work lead receptacle.
8.
Secure the work cable to the work lead receptacle by tightening the bolt.
Figure 94
9.
Complete the following procedures:
a.
b.
Install the power supply cover
c.
Reconnect the power and gas supply.
Front panel
Work lead receptacle
Keyway up
Содержание Powermax 125
Страница 1: ...Powermax125 Plasma Arc Cutting System Service Manual 808070 Revision 1 English ...
Страница 3: ...Powermax125 Service Manual 808070 Revision 1 English April 2014 Hypertherm Inc Hanover NH 03755 USA ...
Страница 6: ......
Страница 56: ...56 Powermax125 Service Manual 808070 4 Hand Torch Setup ...