HydraMaster BoxxerXL, Руководство пользователя

Страница: 64 / 144

Machine Maintenance: 5-18
freeze gUarDIng
To avoid permanent damage to the truckmount, it is imperative to follow the freeze Guard
Procedure whenever the possibility of freezing temperatures exists.
When disposing of antifreeze, follow local laws and regulations. Do not discard
into storm sewers, septic systems or onto the ground.
Antifreeze is harmful or fatal if swallowed. Do not store in open or unlabeled
containers. Keep out of reach of children and animals.
When draining solution from the machine, wear protective eye wear and ensure
the solution temperature is cold. failure to follow this warning can result in
personal injury
freeze guard procedure
1. With the truckmount turned off and the incoming water line disconnected, open the
water box drain valve on the front of the truckmount. Allow the system to fully drain.
Close the water box drain valve.
In some extreme cold-temperature locations, you may find it necessary to
disconnect the pressure gauge hose from the high pressure pump and drain the
hose. Reconnect the hose to the pump before proceeding to step 2.
2. Add 2 gallons (7.57 litres) of 50/50 antifreeze and water mix to the water box.
3.
Attach a recirculation fitting (See the previous page and figure 5-19) to the incoming
water quick connect on the front of the machine.
4. Attach a section of solution hose to the outgoing solution fitting on the front of the
machine. Attach the opposite end to the recirculation fitting. (If more sections of
hose are to be freeze guarded, attach those inline.)
5. Start the truckmount and allow it to run for 2 to 3 minutes.
6. Press the Pump Switch to “PuMP ON HeAT MODe” and allow the machine to run
for 2 minutes. This will distribute antifreeze solution throughout the truckmount.