Hyd-Mech V-25APC, Руководство пользователя

Страница: 40 / 78

2.10
ONE CUT MODE OPERATION
In MANUAL mode, the PLC allows the operator to initiate a ONE CUT MODE to cut one piece at a desired length. To
accomplish this, follow the procedure below.
1. A trim cut should be made before initiating the ONE CUT MODE operation. Key in the required angle using the
keypad and cursors, press “AngleGo” button at the bottom of the screen, then CYCLE START button. The head
will turn to the required area and stop.
2. Press the Infeed Vise Closed push button to activate ONE CUT MODE.
3. Key in the desired length up to 999” using the numeric keypad and press enter.
4. Push the Blade Start button.
5. When the blade is started, the word BLADE will change to the words CYCLE START and will be flashing on the
display window. Press CYCLE START and the cycle will begin.
6. When the cut is completed, the blade will stop, the head will retract back to the limit switch, and the display win-
dow will reset for the next cut.
7. To cut another piece, repeat steps 2 through 6.
NOTES:
1. To pause the ONE CUT CYCLE, press the CYCLE PAUSE button. The CYCLE START button will begin to flash
and the screen will indicate a paused condition. All movements will immediately cease, except blade will continue
to run. In addition, if SHUTTLE is in motion, it will complete it’s movement and then the CYCLE will PAUSE. To
continue the cycle, press CYCLE START.
2. To cut multiple pieces, switch to AUTO MODE and follow the automatic procedures.
3. Whenever a new job or new material is being loaded for production, position the head for a trim cut and the infeed
vise should be closed (in MANUAL MODE).
AUTOMATIC OPERATION
To enter AUTO MODE, the Infeed Vise must be in the closed position. When the AUTO MODE key is pressed,
the red indicator will come on. The screen will change to the JOB display window as shown below and will be ready for
editing or starting a new job. All manual functions will be disabled.
PROCEDURE FOR EDITING OR STARTING A NEW JOB IN AUTO MODE
1. In AUTO mode, key in a job number from 0 to 999, the number of pieces to be cut, the number of pieces already
cut, and the length, pressing enter after each value. If the number of pieces cut equals or exceeds the number re-
quired, the cycle will not start. If the job number has previously been programmed, the number of pieces, length,
and number cut will be displayed. To navigate through the values, use the cursor keys. The values displayed may
be edited by using the numeric keypad and pressing enter. The job will then be stored in memory with the new
values.
2. Two angles, and two lengths define each job. Angle 1 (A1) is the first angle to be cut (this will be the trim cut).
Length 1 (L1) is the length of the material to be cut as measured between the two intersection points of the blade
axis and the saw table datum line. Angle 2 (A2) is the second angle to be cut and Length 2 (L2) again is the length
of material as measured between the two intersection points of the blade axis and the table datum line.
ONE CUT MODE