Hyd-Mech V-25APC, Руководство пользователя

Страница: 36 / 78

2.6
To return to previous screen press exit key.
The Standard kerf and corrected values are as follows:
COLLISION DETECTION FEATURE
Your machine is equipped with a collision detection feature. This feature protects the machine from a collision that hap-
pens when the required angle is less than 45 degrees towards the infeed side of the machine, and the shuttle vise is in
front position. Your machine is equipped with sensors which will prevent this possible collision and cause the head or the
shuttle to stop.
In such cases you will need to retract the shuttle to the back in order to clear the head to go to the required angle. In
Manual Mode: It is a good idea to alter the cut if the required pieces involve this scenario. Flip the piece upside down and
perform the cut when the head is turned 30 degrees towards the outfeed side of the machine where there is no possible
collision as shown in the following example:
Example -1
A rectangular section bar, 30” long, the required cutting angle is 35 degrees.
When the cut is facing upward, a possibility of collision exist, therefore if the shuttle is moved close to the infeed vise, the
head will not swing to the required 35-degree angle. This is to prevent a collision as shown below.
To avoid this scenario, turn the piece upside down, and swing the head 35 degrees in the opposite direction.
Possible Collision
STD KERF @ 90° 75° 60° 55° 50° 45° 40° 35° 30°
1 ¼” BLADE .066 .068 .076 .081 .086 .093 .103 .115 .132
1 ½” BLADE .074 .077 .085 .090 .097 .105 .115 .139 .148