Hyd-Mech V-25APC, Руководство пользователя

Страница: 35 / 78

2.5
MACHINE START UP
Reset the E-Stop by pulling out the red mushroom button. There is a short delay to allow the machine software to load.
Press the machine start button two times: First to wake up the screen saver, and then a second time to start the hydrau-
lics. If the head is not at 90 degrees then the display screen will look as follows.
The following must be done to activate the cutting modes:
1. The guide arm must be in full upward position.
2. The head must be fully retracted.
3. Then the head must pass 90 degrees. The approach can be done in fast speed, but the passing of 90 must be
done in slow.
After the above three points are achieved the screen will change to manual mode.
MANUAL MODE
MANUAL MODE is the default mode. All functions are enabled when in MANUAL MODE.
The screen should look as follows:
The cursor on the display is flashing on ANG REQ’D. Enter a numerical angle then press the enter button. Left or Right is
changed by moving the cursor over to the “L” or “R” and pressing enter. Press the AnglGO button once the desired angle
is chosen. The screen will change and the cycle start push button must be pressed in order to achieve the desired angle.
KERF CORRECTION FOR ANGLE CUTTING (Manual Mode)
When making mitered cuts, the part length must be set longer than the desired length by an amount called the KERF
CORRECTION or the kerf value must be adjusted. This is due to the fact that the PLC will not account for a difference in
the kerf value at various angles. If the kerf value is to be adjusted, its value can be accessed by pushing the next button.