2.6 | MAINTENANCE LOCK
The maintenance lock must be placed into position whenever the machine is being serviced in a partially raised
position. Serious injury and/or death could result if maintenance lock is not used properly.
2.7
| SAFETY GUIDELINES
Only qualified operators may operate this unit.
•
All operators must read and understand the Operation and Safety Manual. They must understand all decals and
warning labels on unit.
•
Do not work on platform if your physical condition is such that you feel dizzy or unsteady in any way.
•
Do not neglect/misuse machine. Report any misuse of equipment to proper personnel.
•
Prevent unauthorized use; when unit is not in use, remove key.
•
It is recommended all personnel on unit wear approved personal protective equipment (PPE), i.e. head gear.
Use machine only for purposes for which it was intended.
•
Lift should never be used as a crane.
•
Do not exceed the load capabilities of the platform.
•
Distribute load evenly over platform floor area.
•
Never use unit as electrical grounds for arc welding.
•
Do not override any hydraulic, mechanical, or electrical safety devices.
Check job site for unsafe working conditions.
•
Watch out for others. Keep others clear of operating platform. Never allow others to pass under a raised platform
or position the platform over someone.
•
Avoid contact with fixed (buildings, etc.) or moving (vehicles, cranes, etc.) objects. Check work area for overhead
obstructions or possible hazards.
•
Follow any applicable national traffic regulations.
•
Use indoors only. Lift is not designed for windy conditions or electrical storms.
•
Unit must be on hard level surface before elevating. Do not operate on incline or uneven surface.
•
You must maintain a clearance between any part of the machine, or its load, and any electrical line or apparatus.
Follow local power line clearance regulations.
•
You must maintain a clearance between any part of the machine, or its load, and any electrical line or apparatus.
Follow local power line clearance regulations.
SECTION 2 | SAFETY
FIGURE 3: Maintenance Pin use
FIGURE 4: Maintenance Pin storage
BY CUSTOM EQUIPMENT LLC
11
OPERATIONS & SAFETY
HB-P3.6
SUPO-725
REV C
