Husqvarna Quilt Designer II, Руководство пользователя

Страница: 45 / 82

Utility Garment Sewing
45
Corded Buttonhole (Stretch Fabrics)
When sewing buttonholes in stretch fabrics Quilt
Designer II recommends to cord the buttonhole to
in crease the stability and to keep the buttonhole
from stretching out.
• Loop a piece of heavy thread or perle cotton over
the fi nger at the back of the Sensor But ton hole
Foot or presser foot C.
• Stitch a buttonhole. Do not hold back the cord.
The satin buttonhole columns will stitch over the
cord.
• Stop sewing with the needle down before the last
bartack end of the but ton hole is sewn and lift the
cord off the fi n ger and pull out the slack.
• Cross the cord in front of the needle and stitch the
last bartack end of the buttonhole over the cord.
• Thread cord ends into a large needle, pull to the
wrong side and knot ends before cutting excess
cord.
Buttonhole Balance
To balance the stitch dens ity of the right but ton hole
column to the left for speciality fabrics, open
when a but ton hole is selected.
will make the stitches in the right
column clos er together (more dense).
will make the stitches further apart (less dense).
The set ting will be re tai ned until Quilt Designer II is
turned off.
Note:
Only the right side stitch column will be adjusted.
Balance it to the left stitch column.
To change the stitch density of both columns, see
Buttonhole Density, below.
Buttonhole Density
To adjust the density of the buttonhole, touch
. Increase stitch length ( ) to make stitch
col umns less dense. Decrease stitch length ( ) to
make stitch col umns more dense. Both col umns will
be adjusted.