Husqvarna Quilt Designer II, Руководство пользователя

Страница: 53 / 82

Quilting with Quilt Designer II
53
Inner border:
Illustration G, H
Piece together on the diagonal, 1 strip for each side
of the quilt top for inner border. To piece on the
diagonal, place them right sides together on a 90
degree angle and stitch on a diagonal to eliminate
bulk at the seams. Press seam al low ance open and
cut away excess seam allowance. Two strips need to
measure at least the length of the quilt plus 8” (200
mm), and two needs to meas ure at least the width of
the quilt plus 8” (200 mm).
Stitch a strip to all four sides of the quilt top, right
sides together, leaving 4” (100 mm) of each strip, at
all four corners, extending from the quilt top corners.
Press seam allowances towards the quilt top.
Miter the border corners by folding the excess strips
to the wrong side and fi nger press a di ag o nal fold
mark. Stitch in the fold mark from the wrong side
starting from the outer edge to the inner corner. Cut
away excess seam al low ance and press open.
Outer border:
Sew the outer border in the same way as the
in ner border but start stitching 8” (200 mm) from
the edge of the strip this time. Two strips need to
measure at least the length of the quilt plus 16” (400
mm), and two needs to measure at least the width of
the quilt plus 16” (400 mm).
Quilting
Piece the backing to form one piece at least the size
of your quilt. Place the backing on a fl at sur face,
wrong side up. Place the batting and the quilt top on
top right side up. Safety-pin baste the layers together
with two safety pins in every block.
Illustration I
Use presser foot A or the optional Open Toe Foot for
better visibility. Select stitch A
1
02 on stitch d-Card A
1
.
Thread the machine with sew ing thread matching the
darker outer logs of the blocks on top, and sewing
thread matching the backing in the bobbin. Quilt
through all layers following the individual log cabin
blocks as il lus trat ed. The Sensor System feeds the
layers even ly. Touch Needle Stop Down to pivot at
the corners with the needle in the fabric.
The Sensor System actually ”senses” the exact piv ot
height for the presser foot.
Illustration G
Illustration H
Illustration I