Husqvarna Quilt Designer II, Руководство пользователя

Страница: 54 / 82

Quilting with Quilt Designer II
54
After fi nishing the pattern of the dark logs,
rethread with sewing thread matching the lighter logs
and continue to in the same way to quilt along the
edge of the light logs.
Quilt through all layers around the quilt top and
around the inner frame.
Remove the safety pins. Trim all raw edges even.
Binding
Rethread the machine with sewing thread match ing
the binding fabric on top and bobbin.
Illustration J
Cut 2 3/4” (70 mm) wide strips in fabric G, and
sew them together, to go all the way around the
quilt. (You will need about 425” (10.60 m). Sew the
binding strips together with di ag o nal seam as before
to reduce the bulk in the seam al low ance, by placing
two strips right sides
together, at a 90-degree angle and stitching on the
di ag o nal.
Illustration K
Trim the seam allowances to 3/8” (9 mm) and press
open.
Illustration L
Sew the remaining strips in the same way. Fold in
half lengthwise, wrong sides together, and press.
Starting at the bottom edge of the quilt, lay a bind ing
strip on the wrong side of your quilt, raw edges
aligned. Touch needle stop down. Start stitching 2”
(50 mm) in from the beginning of the binding and
stop when you get to 1/4” (6 mm) from the fi rst
corner. When the needle stops down, the Sensor
Foot Pivot automatically raises the presser foot
sensing the exact pivot height for your fabric layers.
Pivot towards the corner, and stitch diagonally off
the corner.
Illustration M
Fold the binding across the diagonally stitched line
and back on itself along the right side.
Illustration N
Start sewing again, 1/4” (6 mm) from the corner.
Con tin ue this way all the way around.
Illustration J
Illustration K
Illustration L
Illustration M
Illustration N