Huskylock 90
24
Rolled hemming
When sewing rolled hemming, the loops
formed by the upper looper thread,
should be pulled to the underside of the
fabric. This is done by setting the tensions
as shown on page 17.
Back
Front
Narrow hemming
For seams on sheer or lightweight fabrics.
Set the tensions as shown on page 17 for
a balanced tension.
To carry out either of the above sewing tasks, please proceed as follows.
1) Refer to page 23 "Convertibel presser foot".
2) Turn the handwheel toward you until the needles are fully raised.
3) Open the front cover and remove the left needle. See page 22.
4) Set the stitch length between 1.0-2.0 mm. See page 20. Also ensure that differential
feed is set at the "N" position. See page 26.
5) Adjust the stitch width as shown on page 21.
6) If not already threaded, re-thread the machine.
7) Place the fabric under the presser foot and start to sew.
Always test the stitch and the tension setting on a spare fabric before sewing on your
actual garment.
When sewing either Rolled or Narrow hemming we recommend that you change the
threads as shown on page 17.
Always remember to re-set the special foot adjuster after you have finished your hemming
procedures.
Rolled and narrow hemming
Needle thread
Upper looper thread
Lower looper
thread
1,5 mm
1,5 mm
Needle thread
Back
Front
Lower looper thread
Upper looper thread
