Version January 2009
20
EN
HST300 User’s Manual
H Ü R N E R S c h w e i s s t e c h n i k G m b H
Nieder-Ohmener Str.
35325 Mücke, Germany
the upper limit depends on the load value and is calculated as the cur-
rent at start plus 15%.
11.2.7 Emergency Off
The welding process has been interrupted by pressing the STOP/RESET
key.
11.2.8 Heater Coil Error
The current value during welding differs by more than 15% from the
nominal value, indicating a short-circuit in the heater coil.
11.2.10 Power Supply Failure
The last welding is incomplete. The welding device was disconnected
from power supply voltage.
12 HST300
Pricon
+ Technical Specifications
Nominal Voltage
230 V
Frequency
50 Hz - 60 Hz
Power
2800 VA, 80 % ED
Protection Index
IP 54
Primary Current
16 A
Ambient Temperature
- 20 °C to + 60 °C
Output Voltage
8 V - 48 V
Max. Output Current
110 A
Memory for Reporting Protocols
2000 reports
Tolerances:
Temperature
± 5 %
Voltage
± 2 %
Current
± 2 %
Resistance
± 5 %
USB A Interface
(at the front of the unit)
for connecting USB printers and USB mass storage media (such as
a USB stick)
USB B Interface
(at the back of the unit)
for connecting the welding unit directly to a PC
Both interfaces comply with the USB version 1.1 specification (i.e., maxi-
mum data rate of 12 megabits per second).
Important
To work properly, the used printer has to support PCL (Printer
Command Language). Please refer to the manual of your
printer for more information. A list of supported printer makes
is also available from Hürner Schweisstechnik on-line at
www.huerner.de
13 Service and Repair Contact
Hürner Schweisstechnik
Nieder-Ohmener Str.
Tel.: +49 (0)6401 9127 0
35325 Mücke, Germany
Fax: +49 (0)6401 9127 39
Web: www.huerner.de
E-mail: [email protected]
Info
We reserve the right to change technical specs of the unit
without prior notice.
