INSTALLATION
16
■
Secure the three cord anchors attached to the individual cords routed through the non-
stacking side end cap. Be sure that the cords are not twisted before beginning.
➤
Start with the cord anchor that has the shortest cord. Hook the anchor between the first
set of marks in the front channel of the headrail and secure it using the Allen wrench.
➤
Install the cord anchor with the next shortest cord in a similar manner.
➤
Finally, install the cord anchor with the longest cord.
IMPORTANT:
Make sure that the cords do not twist together.
Proceed to “Complete the Installation” on page 18.
Split Stack
NOTE:
Each fabric panel has its own set of cord tensioners. Install all four cord tensioners for
one panel before installing the cord tensioners for the other panel.
■
Move the vertical rails of each panel within 6" of each end and 6" of the stop plate in the
center of the rail. Adjust the position of the rails as needed when installing the cord anchors.
■
Attach the end caps on outside mount shades. (End caps on inside mount shades should
already have been installed.)
➤
Loosen the screw on each end cap until it is flush with the top.
➤
Push the end caps into place on the headrail. Hold the cords below the end cap on the
moving rail side when installing it. Be careful not to pinch or twist the cords.
➤
If necessary, tap the end caps in place with a rubber mallet.
➤
Tighten the screw on both end caps.
■
Locate the single cord anchor connected to the three cords coming from the top of the
secondary rail.
➤
To secure the cord anchor, first locate the two marks on
the front channel of the headrail near the stacking end.
➤
Hook the cord anchor between the two marks on the front
channel.
➤
Use the provided Allen wrench to tighten the cord anchor
just until snug to secure it to the channel.
IMPORTANT:
The three cords attached to the cord anchor
may need minor tension adjustment. Final cord adjustment
will be explained later in these instructions.
Tighten with
Allen Wrench
Cord Anchor
in Front
Channel
Marks
Front
Channel Cord
Anchor
Bottom View
Front Channel
Bottom View
3
1
2
