INSTALLATION
— Inside Mount
12
Joining Plate
Tabs Angled
Down Toward
Headrail
Stop Plate
Assemble the Shade
With inside-mounted applications, the shade is pre-assembled before the headrail is installed.
Lay out all the components for assembly on a clean, cloth-covered surface. Position the headrail
near the top of the vertical rails.
Assemble the Headrail (Two-Piece Headrails Only)
■
Split stack only:
Headrails may arrive in two separate pieces depending on ordered width.
The two pieces are connected with a joining plate.
➤
Insert the joining plate into the top back channel of one of the headrail pieces. The tabs
on the joining plate are slightly angled. Place the joining plate so that the tabs angle
down toward the headrail.
➤
Slide the joining plate completely onto the headrail so that no part of it protrudes.
➤
If the stop plate is protruding from one of the headrail pieces, slide it all they way into the
headrail so that it does not protrude. Loosen the screws with the provided Allen wrench,
if necessary.
➤
Position the two headrail sections so that they abut in the center.
➤
Using a flat blade screwdriver, center the joining plate between the two headrail sections.
Be careful not to damage the fabric-covered headrail.
➤
Position the stop plate so it is centered on the joint between the headrails. Tighten the
stop plate screws using the provided Allen wrench.
Center Over Split
