Hunter Douglas Silhouette DuoLite, Установка Эксплуатация Уход

Страница: 27 / 44

OPERATION
25
Further Operation and Programming Information
PowerView
®
Pebble
®
Remote and/or PowerView
®
Surface Remote Operation
For information regarding operation and programming of the PowerView
®
remote, refer to
your PowerView
®
Automation Remote Control Guide or to the online PowerView Step-by-Step
Guide at hunterdouglas.com/operating-systems/motorized/powerview-motorization/
manuals.
PowerView
®
Scene Controller
For information regarding operation and programming of the PowerView
®
Scene Controller,
refer to your PowerView Automation Scene Controller Guide or to the online PowerView
Step-by-Step Guide at hunterdouglas.com/operating-systems/motorized/powerview-
motorization/manuals.
PowerView
®
App Operation
The PowerView
®
Hub is required for PowerView
®
App operation. For information regarding
setup and operation using the PowerView App, refer to the online PowerView Step-by-Step
Guide at
hunterdouglas.com/operating-systems/motorized/powerview-motorization/
manuals.
Resetting the Shading (If Necessary)
Calibration Reset
The calibration reset is used to recalibrate the shading’s travel limits.
1. Press and hold the programming button for approximately 6 seconds. The shading will move
slightly. Release the programming button (the light flashes red).
2. Both the front shading and rear shade will raise to their fully open positions to set the upper
travel limit, then lower to their fully closed positions to reestablish the lower travel limit. The
rear shade will move slightly twice (up, then down) to indicate that the travel limits
were recalibrated.
Resetting Shading Programming
The programming reset erases shade programming from memory, including group
assignments, preventing input devices from operating the shading. The primary use is to
correct group and network assignments during installation. The reset does not affect travel
limits or the favorite position.
1. Press and hold the programming button for approximately 12 seconds. The shading will
move slightly after 6 seconds, then again after 12 seconds. Release the programming
button (the light flashes red). The light then flashes a series of green and red to indicate
that shading programming is erased from memory.
2. Refer to “Joining a Shading to a Group” on page 23 to program the shading to a group.