Hunter Douglas Silhouette DuoLite, Установка Эксплуатация Уход

Страница: 24 / 44

OPERATION
22
PowerView
®
Automation
Test the Shading
Use the programming button to test the shade and ensure that the motor and power source
are working correctly. Each press of the programming button will initiate one of six shade
movements, in sequential order.
■
With the shading in the fully raised position, press and
release the programming button. The front shading
moves to the fully lowered position with vanes closed.
If the shading does not operate, see “Troubleshooting”
on page 26.
■
Press and release the programming button a second
time. The vanes open.
■
Press and release the programming button a third time.
The rear shade moves to the fully lowered position.
■
Press and release the programming button a fourth
time. The rear shade moves to the fully raised position.
■
Press and release the programming button a fifth time. The vanes close.
■
Press and release the programming button a sixth time. The front shading moves to the
fully raised position.
Using the PowerView Remote
Refer to the illustration below to familiarize yourself with the controls on the remote. Activate
the remote by pulling both plastic tabs from the back battery compartment.
IMPORTANT: If you have more than one remote, see “Adding Additional Remote(s) to the
PowerView
®
Shade Network” in the PowerView Automation Remote Control Guide .
Group 1
Group 2
OPEN
(Raises rear shade, closes vanes,
and raises front shading)
CLOSE
(Lowers front shading, opens
vanes, and lowers rear shade)
Group 3
Group 4
Group 5
Group 6
Favorite
(
Set to a front shading’s position;
vanes closed, rear shade fully raised)
LEFT ARROW
(Raises rear shade, lowers
front shading, and closes vanes)
RIGHT ARROW
(Raises rear shade, lowers
front shading, and opens vanes)
STOP
(All shade movement stops)
(Press and hold for programming mode)