Installation
The SC 110 Autopilot includes hardware and a template to mount
the control head in the dashboard. You may also purchase gimbal
mount hardware and extension cables for your installation.
Contact our Customer Resource Center for details.
The SC 110 Autopilot control head connects to the SCP 110 Course
Computer (CPU) so that it receives input from the Fluxgate
Compass, Gyronav Rate Sensor, GPS receiver, and all connected
autopilot equipment.
WARNING!
The CPU and all related equipment should be
installed by a Certified Marine Electronics Technician
(CMET) or an authorized Marine Electronics Installer
(MEI). See NMEA.org for details.
1.
Connecting the Control Head to the CPU
1.
Turn off the power to the CPU.
2.
Test route the power cable from the CPU to the
autopilot control head.
3.
Remove the CPU cover and insert the cable through
the CPU strain relief for the correct terminal, and
proceed as follows:
•
Unit 1 (TB7):
Remove the terminated block from
the TB7 Control Unit 1 connector. Insert the bare
wires of the Power/CPU cable into the terminated
block connector as shown in
Inserting the Wires
into the Terminated Block
.
•
Unit 2 (TB8):
If you are connecting a second
autopilot (optional-purchase Remote SC 110
Control Head), remove the terminated block from
the TB8 Control Unit 2 connector. Insert the bare
wires of the Power/CPU cable into the terminated
block connector as shown in
Inserting the Wires
into the Terminated Block
.
2
Installation
