Wait:
You may have to
steer the vessel so it
completes 2 or 3
complete circles. The
screen will display “Wait”
during this procedure.
3.
When the procedure
is complete, the screen
will display SUCCESS or
FAILED. If the procedure
was successful, press the
STANDBY/POWER key
to exit.
Adjust:
If the compass
setting must be tweaked
slightly to match the
analog compass, see the
Compass Alignment
setting in
Control Head
Configuration: Input
Installation Settings
.
If the procedure failed:
The compass might be installed in a
location with too much magnetic interference. Check the compass
location and possible magnetic disturbances in the area.
4.
Confirm the Compass Reading:
Compare the compass
reading on the screen with the vessel’s main magnetic
compass.
If there is a big difference in the readings:
Check the
compass installation location, or turn it on its vertical
axis until the difference is cancelled. Zero the compass
setting and follow the steps in the Automatic Compass
Compensation section.
23
Test the Autopilot
