4.
If the gasket has a foam
center, remove the center.
5.
Peel off the liner of the
adhesive side of the
gasket. Place the gasket’s
adhesive side on the rim
on the back of the control
head.
6.
Insert and tighten the
two threaded rods into
the two threaded
inserts located on the
back of the control
head (see
Attaching
the Bracket
).
7.
Peel off the second liner
from the gasket, and
insert the control head
through the mounting
hole from the front side
of the dashboard.
8.
Slide the bracket onto the
two threaded rods.
9.
Place a flat washer onto
each threaded rod, and
then secure the bracket
by placing a lock
washer and wing nut
onto each threaded rod.
Hand tighten only.
Do not overtighten the
wing nuts.
Attaching the Bracket
Threaded
Rod
Flat
Washer
Bracket
Wing Nut
Lock
Washer
Dashboard
(partial view)
Attaching the Foam Pad
Gasket
Rim
Hollow
Center
5
Installation