Hughes HX100, Руководство по установке

Страница: 93 / 138

Chapter 7 • The System Control Center
1037106-0001 Revision B.03-Draft
75
•
Frames received -
reports the number of data messages
received by the remote terminal over the satellite link.
•
Frames with Errors - reports the percentage of received
frames that were found to be corrupt. A continuously
increasing value of frames with errors is an indication that
problems exist within the receive path. This may be the result
of adverse weather conditions or a problem with the receive
cable or the antenna. However; a low number of frames with
errors is no reason for concern, as long as the number does
not increase and the system is functioning properly.
•
Bad Key Frames -
indicates the percentage of received
frames that could not be decrypted successfully. All data
received over the satellite is encrypted. A continuously
increasing value indicates that the remote terminal has not
been properly commissioned.
Receive status messages Table 4 lists the messages that may appear in the
Receive Status
field. The Corrective Actions column provides detailed
information about each code and describes any possible
corrective measures.
If a problem cannot be resolved by following the corrective
measures, contact technical support.
RxCode 5 indicates that the remote terminal is receiving data
properly. This is the code you should see most often.
Table 4: Receive code (RxCode) messages and corrective actions
Code Message Corrective actions
1 The receiver is in pointing mode Indicates that the installer is performing
antenna pointing. In this mode, the transmitter
is disabled because the installer is working
near the dish. If this occurs during normal
operation, power-cycle the remote terminal by
unplugging the power cord from the power
source and plugging it back in.
2 The receiver is in factory or GTWY mode Used for remote terminal testing purposes only
and should never appear during normal
operation. If it appears during normal
operation, power-cycle the remote terminal by
unplugging the power cord from the power
source and plugging it back in.