Hughes HX100, Руководство по установке

Страница: 123 / 138

Appendix B • Updating the remote terminal software
1037106-0001 Revision B.03-Draft
105
8. Click OK .
9. Restart the computer even if Windows does not require you
to do so. This ensures that the network settings are
automatically reset.
Updating the
fallback.bin file Follow the steps below to update the
fallback.bin
file. During
this process, the files containing the current software release are
transferred to the remote terminal, overwriting the older files.
1. Confirm that the installer laptop Ethernet cable is connected
to the LAN1 port of the remote terminal by performing a ping
test:
a. Open a command window on the installer laptop.
b. Type
ping 192.168.0.1
. If an alternate IP address was
assigned to the remote terminal at the HX GTWY, ping
that IP address instead.
c. Press E
NTER
.
Continue with step 2 if the ping test is successful. Refer to
Troubleshooting on page 106 if the ping test fails.
2. Navigate to the location on the laptop where you saved the
Fallback Updater utility and its supporting files in Step 4 of
Saving the utility on the installer laptop on page 97.
3. Launch the Fallback Updater utility by opening the
HX_Updater.exe
file.
4. Type
192.168.0.1
in the IP address field on the HX
System Updater window as shown in Figure 72. If an
alternate IP address was assigned to the remote terminal at
the HX GTWY, use that IP address instead.
5. Click OK .
During the update process, status messages will appear in the
message window between the address field and the
OK button.
When the update is complete, the utility automatically closes and
the remote terminal reboots.
Refer to Troubleshooting if the utility does not automatically
close or the remote terminal fails to reboot.
Figure 72: Entering the remote terminal IP address