Hughes DIRECWAY DW7000, Руководство пользователя

Страница: 16 / 98

Chapter 1 • Introduction
2
1035978-0001 Revision A
Remote terminal
overview
Congratulations on your purchase of a DIRECWAY
®
model
DW7000 or DW7700 remote terminal! After your terminal has
been professionally installed, you can use a web browser to surf
the Internet. You will also be able to operate a local area network
(LAN) after you configure your computers with network interface
cards (NICs), connect them with Ethernet cable or through a
wireless base station, and configure your computers’ operating
system network properties.
The terminal has a System Control Center that provides access to
system information such as your site account number (SAN), site
ID, terminal Internet Protocol (IP) address, and subnet mask; the
terminal IP address and the subnet mask may be required to
configure a network. The System Control Center is described in
Chapter 2 – System Control Center, on page 7.
The instructions in this manual also apply to the enterprise-class
DW7700 terminal. The DW7700 terminal includes the
functionality of a DW7000 terminal in addition to being equipped
with an internal telephone modem, serial port, and two Ethernet
ports. The model number appears on a label next to the DC IN
connector on the back of the terminal.
In this guide, the terms remote terminal and terminal may refer to
a DW7000 or DW7700 model remote terminal. The terms
DW7000 and DW7700 are used when it is necessary to
differentiate between the two models.
System requirements
Make sure your computer meets the following minimum
requirements to achieve optimal terminal performance:
•
Operating system
– PC: Windows 98 Second Edition (SE), Windows
Millennium Edition (Me), Windows 2000, Windows XP
– MAC: 10.1 or higher
•
Processor
– PC: Pentium II 333 Mhz or faster
– MAC: 300 Mhz or faster
•
Memory
– PC: 64MB RAM, Windows 98SE and Me; 128MB RAM
Windows 2000 and XP.
– MAC: 128MB
•
Free hard drive space
– PC: 100MB
– MAC: 150MB