Hughes DIRECWAY DW7000, Руководство пользователя

Страница: 55 / 98

Chapter 4 • Troubleshooting
1035978-0001 Revision A
41
If the LAN LED dims
If the LAN LED goes dim, follow these steps:
1. Plug the Ethernet cable back into the Ethernet port.
2. Check the IP address assigned to the computer.
a. In Windows, go to
Start
→
Run
. The Run box appears.
b. Type
command
in the
Open
field and click OK. The
Command window appears.
c. Type
ipconfig
at the prompt and press E
NTER
.
Information related to the computer’s network
configuration appears.
d. Check the IP Address field . If the IP address is set to
0.0.0.0
or to an address that begins with
169.254
, make
sure the TCP/IP settings for your NIC are configured to
automatically obtain an IP address. Refer to Appendix B –
Typical operating system settings, on page 51.
If the TCP/IP settings are correct, power cycle the
computer; this sets the IP address correctly.
If the ipconfig command did not display IP address
information, there might be a problem with the NIC. Refer
to the manufacturer’s documentation.
3. If the System Control Center is still not available, try pinging
the terminal by typing
ping 192.168.0.1
at a DOS
command line and pressing E
NTER
.
If ping does not work, power cycle the terminal by
unplugging it from the power source, waiting 10 seconds, and
plugging it back in. If you still cannot ping, contact customer
support.
If the ping results show
request timed out
, then power
cycle the unit.
You should now be able to access the System Control Center.
If you cannot, contact customer support.