Install the seat post into the seat tube:
CAUTION:
If you accidentally drop the seat post
into the seat tube, it may be difficult to remove it.
Install post clamp on seat tube:
- Put the clamp on the seat tube. Push the clamp
[1] down so you can see 1/16 inch [2] of the seat tube
[3] above the clamp.
NOTE:
Some post clamps are welded in position and can not be moved.
- If the post clamp has a raised edge, make sure the raised edge is against the top of the seat tube.
Assemble the red reflector to the rear reflector bracket:
- Push the rear reflector bracket [4] into the back of the
red reflector [5]
- Make sure the stud [6] of the red reflector goes into
the hole [7] of the rear reflector bracket.
Assemble the rear reflector bracket to the post clamp
with hardware:
WARNING:
Install the rear reflector bracket
exactly as shown or the visibility of the red
reflector will be reduced.
- Install a bolt [9] and nut [8] or a quick release
lever (see Quick Release Operation section) as shown
- Do not tighten the bolt and nut or quick release
lever at this time.
WARNING:
Every time you loosen the quick release mechanism, make sure the red reflector
is correctly positioned if the reflector is mounted on the seat post or seat pillar.
- Try to turn the seat side-to-side and to move the front of the seat up and down
- If the seat moves in the seat clamp
- Loosen the seat clamp
- Put the seat in the correct position and tighten the seat clamp tighter than before
- Do this test again, until the seat does not move in the seat clamp
8
9
