Handlebar Mount - Style 1 and Style 2
Assemble to the handlebar:
- Put the clamp [1] as near the handlebar stem as possible
NOTE:
If you have Style 1, make sure the bracket points towards the
ground.
- Hold the reflector in this position and tighten the screw(s) [3].
Operation and Maintenance
WARNING:
For your own safety, do not ride the bicycle if the
reflectors are incorrectly installed, damaged, or missing. Make
sure the front and rear reflectors are vertical. Do not allow the visibility
of the reflectors to be blocked by clothing or other articles. Dirty
reflectors do not work well. Clean the reflectors, as necessary, with
soap and a damp cloth.
Rear Reflector Bracket and Red Reflector Assembly
This section covers the assembly of the rear reflector to the rear reflector bracket. Determine which
style you have before beginning assembly.
Snap
In
Style
Screw
In
Style
Reflector Assembly
Assemble the red reflector to the rear reflector bracket:
WARNING:
Install the red reflector exactly as shown or it will not operate correctly.
Snap In Style
- Push the reflector [1] onto the reflector bracket [2]
- Make sure the stud [3] on the reflector goes into the hole [4] of the bracket with a “snap” sound.
Screw In Style
- Put the reflector onto the reflector bracket
- Make sure the studs on the back of the reflector go into the holes of the reflector bracket
- Put the screw [?] through the bracket and into the reflector
- Tighten screw.
