INSTALLATION MANUAL
Page 2 of 15
HUBER+SUHNER disclaims any liability resulting from incorrect installation and use, including any damages resulting from the use of tools and
accessories other than the ones recommended herein. Any installation performed by unqualified personnel voids the product warranty provided by
HUBER+SUHNER. All due care and attention must be exercised when performing the installation of these products. For advice concerning the
general handling of these products please contact HUBER+SUHNER.
RRH END OF ASSEMBLY
Step 1
Use a smartphone to scan the QR code which is attached on the
side of the reel. The QR code leads on HUBER+SUHNER
website with the latest valid revision of the installation video and
installation manual.
Step 2
Remove all packaging material from the spool including the
cable stability bracket.
Mount the cable spool onto suitable de-reeling equipment.
Start unwinding side where the braided tube is attached. Do not
pull side where pulling tube is attached. Make sure, that the
spool can turn freely when unspooling.
Step 3
Rig a rope to allow cable assembly to be hoisted up.
Feed the rope through the loop in the braided tube and down
onto the cable hoist.
Pull Assembly up the mast.
NEVER pull on the divider or the breakout (Fiber
optic or power itself), only pull on the hybrid cable
below the divider using cable hoist.
Check the maximum weight indicated on the label. The values
refer to an outside temperature of 50° C and a holding time of 1
hour.
Do not apply higher force! The maximum pulling force equates to
the weight of 100 m of cable. The cable weight is specified on
the data sheet. Cabling systems longer than 100 m may not be
lifted more than 100 m vertically unless a second hoisting grip is
used in addition to the standard hoisting grip. Install the second
hoisting grip on the cable according to the separate instruction.
Contact HUBER+SUHNER for further installation instructions.
Step 4
Once the divider is at the desired height and position, remove
cable tie from braided tube end and slide the blue tube up to get
access to the housing.
