INSTALLATION MANUAL
Page 6 of 15
HUBER+SUHNER disclaims any liability resulting from incorrect installation and use, including any damages resulting from the use of tools and
accessories other than the ones recommended herein. Any installation performed by unqualified personnel voids the product warranty provided by
HUBER+SUHNER. All due care and attention must be exercised when performing the installation of these products. For advice concerning the
general handling of these products please contact HUBER+SUHNER.
Step 11
The remote radios are connected with fiber optic jumpers, which
are terminated with Q-ODC-2 plug connectors and RRH
compatible interfaces.
MLEH versions with connectorised power breakout use power
jumpers which are terminated with a rugged circular plastic plug
connector and are blunt cut on the RRH side.
power jumper optional
Step 12
Connect the Q-ODC-2 plug connectors on the fiber optic
jumpers with the Q-ODC-2 extension connectors on the MLEH
breakout cables, which are marked with labels numbered 1 to 6
(12 or 18).
Mating:
Remove protection caps of the plug and extension connectors.
Connect instantly the jumper cable to avoid ingress of water or
dirt. Push plug connector slightly into extension connector, rotate
to find keying position, push connector to mate.
Mated - connector snaps in and is fully strain relieved.
Connect the two protection caps together for later reuse
optionally.
Un-mating:
Pull coupling ring to un-mate. Mount instantly the protection cap
to avoid ingress of water or dirt.
All HUBER+SUHNER fiber optic assemblies are
100% manufactured in an industrial environment
and are governed by standards which are
implemented and controlled within the factory
environment. The fiber optic cable assemblies as
well as the fiber optic systems are inspected for insertion loss
and the cleanliness of the ferrule end face. Factory-terminated
fiber optic connectors supplied to the market are cleaned and
ready for installation.
Despite our careful control, contamination of dust or
microscopically small parts on the end faces cannot be 100%
excluded.
If cleaning is necessary see cleaning instruction on
www.hubersuhner.com/en/support
