Command Manual – Routing Protocol
Quidway S3900 Series Ethernet Switches-Release 1510
Chapter 1 Static Route Configuration
Commands
Huawei Technologies Proprietary
1-3
Description
Use the
display ip routing-table acl
command to display the routes that filtered
through a specific basic ACL.
This
command is used to track and display the results of route policy. It displays and
only displays the routes that filtered through the basic ACL you specified by an ACL
number.
Example
# Display the summary of the active routes that filtered through basic acl 2000.
[Quidway] acl number 2000
[Quidway-acl-basic-2000] rule permit source 10.1.1.1 0.0.0.255
[Quidway-acl-basic-2000] rule deny source any
[Quidway-acl-basic-2000] display ip routing-table acl 2000
Routes matched by access-list 2000:
Summary count: 2
Destination/Mask Protocol
Pre
Cost
Nexthop Interface
10.1.1.0/24
DIRECT
0
0
10.1.1.2
Vlan-interface1
10.1.1.2/32
DIRECT
0
0
127.0.0.1
InLoopBack0
For detailed description of the output information, see Table 1-1.
# Display the verbose information of the active and inactive routes that filtered through
basic acl 2000.
<Quidway> display ip routing-table acl 2000 verbose
Routes matched by access-list 2000:
+ = Active Route, - = Last Active, # = Both * = Next hop in use
Destinations: 2 Routes: 2
Holddown: 0 Delete: 0 Hidden: 0
**Destination: 10.1.1.0 Mask: 255.255.255.0
Protocol: #DIRECT Preference: 0
*NextHop: 10.1.1.2 Interface: 10.1.1.2(Vlan-interface1)
State: <Int ActiveU Retain Unicast>
Age: 35:37:03 Cost: 0/0
**Destination: 10.1.1.2 Mask: 255.255.255.255
Protocol: #DIRECT Preference: 0
*NextHop: 127.0.0.1 Interface: 127.0.0.1(InLoopBack0)
State: <NoAdvise Int ActiveU Retain Gateway Unicast>
Age: 35:37:03 Cost: 0/0