DIN Rail mount
Attach the DIN Rail Clip to the two wall mount plates. The DIN Rail
should comply with DIN EN50022 standard. Using wrong DIN rail may
cause unsafe installation.
Quick Installation Guide
Industrial 5-port Unmanaged
Ethernet Switch
DS105
DS105 is a cost effective industrial 5-port Ethernet switch for industrial
Ethernet connection. The rugged design can stand for harsh
environment and wide temperature (from -40 to 75
°
C) use. Ultra low
power design consumes less than 1W during full traffic. The compact
size can fit in for space limited installation such as vehicle wall-
mounting or Din-mount for cabinets. Micro USB DC 5V power input is
flexible for installation.
・
Overview
✓
1 x Product Unit
✓
1 x 3-pin Removable Terminal Connector
✓
1 x DIN Bracket set
✓
1 x Quick Installation Guide
Optional Accessory (for detailed information please refer to the
Datasheet)
・
Package Checklist
www.womaster.eu
Wall mount
Two wall mounting plates are installed at the left and right side of the
switch. Use the two hook holes at the corners of each wall mounting
plate or the middle hole to hang the switch on the wall them then
screw tightly.
・
Installation
LED
Status
Description
PWR
Green On
DC-IN Power is On
Off
No Power in DC-IN
Ethernet Port
(Port 1~5)
Green On
Links established
Green Blinking
Packets transmitting/receiving
Off
Link is inactive
Wall Mount Clip
USB POWER INPUT
5 VDC
DC 5 ~ 30V
V+
V-
G
** Caution:
Do not connect the power supply before and after
wiring to avoid damage or electric shock.
** Note:
It is supported with Redundant power design:
5~30V/USB 5V
Power Input (Terminal Block or Micro USB)
Terminal Block
1) Insert the positive and negative wires into the V+, V- and G contact
on the terminal block connector.
2) Tighten the wire-clamp screws.
3) Connect the power wires to suitable DC Switching type power
supply.
Bottom Panel
3
4
5
Top Panel
1
2
Power
Connector
Micro USB
Power Input
LNK
ACT
PWR
1
2
4
3
5
・
LED Indicator
➢
Turn off DC power input source before connecting the DC Power
supply module to the terminal block connectors. Do not turn-on the
source of DC power module and make sure all connections were well
established, then power on the DC source to powering the Switch
device.
➢
Never install or work on/with the equipment or the cabling during the
period of lightning activity.
・
Safety Precautions
・
Appearance
DS105
Wall Mount Clip
System LED
・
1 x Power
・
5 x Ethernet Port
USB 5V Power Input
・
Micro USB connector
Ethernet Network
・
5-port 10/100MBase-TX
(3-port on top, 2-port on bottom)
Wall Mount Clip
Integrated Power
Connector
・
3-Pin Removable
Terminal Connector
