HPE AR64z, Руководство по техническому обслуживанию и ремонту

Страница: 24 / 82

This method initiates a controlled shutdown of applications and the OS before the server enters
standby mode.
• Press and hold the Power On/Standby button for more than 4 seconds to force the server to enter
standby mode.
This method forces the server to enter standby mode without properly exiting applications and the OS.
If an application stops responding, you can use this method to force a shutdown.
• Select a power down action in the AMI MegaRAC SP-X GUI.
This method initiates a controlled remote shutdown of applications and the OS before the server
enters standby mode.
Before proceeding, verify that the server is in standby mode by observing that the power LED is amber.
Remove the server
CAUTION: To prevent improper cooling and thermal damage, do not operate the chassis unless all
bays are populated with a component or a blank.
CAUTION: To avoid damage to the server or server blank:
• Always support the bottom of the server or server blank when removing it from the chassis.
• Do not use the release lever to carry the server or server blank.
Procedure
1. Back up all server data.
2. Power down the server on page 23.
3. Disconnect all peripheral cables from the server.
4. Remove the server:
a. Loosen the release lever thumbscrew.
b. Open the release lever.
c. Use the release lever to pull the server out of the chassis.
24 Removal and replacement procedures