Chapter 7
Installing a Second Processor
43
Leave the processor module in the anti-static container until
you are ready to install it.
Use an anti-static wrist strap and a grounding mat.
Before you remove a processor module from the anti-static
container, touch a grounded, unpainted metal surface on the
HP NetServer E 60 to discharge static electricity.
1. Remove the terminating resistor module from the secondary processor slot
as shown in the following illustration. First, unclip the two plastic
securing clips that hold down the resistor module. Hold the resistor
module by its edges and pull directly upward (see Figure 7-2).
Figure 7-2. Removing the Terminating Resistor Module
2. Align the second processor module over the secondary processor module
slot so that the heat sink faces the same direction as the processor module
already installed (see Figure 7-3).
3. Firmly push down on the second processor module until it is fully seated.
