Battery connector board
Description
Spare part number
Battery connector board (includes cable)
744033-001
Before removing the battery connector board, follow these steps:
1.
Turn off the tablet. If you are unsure whether the tablet is off or in Hibernation, turn the tablet on, and
then shut it down through the operating system.
2.
Disconnect the power from the tablet by unplugging the power cord from the tablet or the Retail Jacket.
3.
Disconnect all external devices from the Retail Jacket.
4.
Remove the top cap (see
Top cap on page 63
).
5.
If installed, remove the tablet from the Retail Jacket (see
Top cap on page 63
).
6.
Remove the front cover (see
Front cover on page 65
).
Remove the battery connector board:
1.
Turn the front cover upside down with the top toward you.
2.
Disconnect the battery connector board cable (1) from the system board.
3.
Remove the two Phillips PM1.9×3.0 screws (2) that secure the battery connector board to the
front cover.
4.
Lift the bottom edge of the battery connector board (3) until the board rests at an angle, and then slide
the board out of the opening in the front cover.
5.
Remove the battery connector board and cable.
Retail Jacket component replacement procedures
71
