2.
Release the ZIF connector (1) to which the forward-facing webcam cable is attached, and then
disconnect the forward-facing webcam cable (2) from the system board.
3.
Remove the forward-facing webcam and cable.
Reverse this procedure to install the forward-facing webcam.
Slot cover
NOTE:
The slot cover is included in the Button Kit, spare part number 747634-001.
Before removing the slot cover, follow these steps:
1.
Turn off the tablet. If you are unsure whether the tablet is off or in Hibernation, turn the tablet on, and
then shut it down through the operating system.
2.
Disconnect the power from the tablet by unplugging the power cord from the tablet.
3.
Disconnect all external devices from the tablet.
4.
Remove the display assembly (see
Display assembly on page 28
), and then remove the
following components:
a.
NFC antenna (see
NFC antenna on page 35
)
b.
WWAN module (see
WWAN module on page 36
)
c.
Power button board (see
Power button board on page 42
)
d.
Battery (see
Battery on page 48
)
e.
System board (see
System board on page 50
)
Remove the slot cover:
1.
Remove the four Phillips PM1.3×2.0 screws (1) that secure the slot cover retention bracket and spring
bracket to the bottom cover.
2.
Remove the slot cover retention bracket (2) and the slot cover spring bracket (3).
Tablet component replacement procedures
55
