4.
Type
1
to assign SP Mode option for file transfer/remote operations and press
ENTER.
Type of transport control
Enter Control-C at any time to abort this process
You have two options for file transfer/remote operations:
1 ==> SP Mode where inbound/outbound access is via ssh session and control
is via the Customer Controlled Access (CCA) setting.
2 ==> Secure Network Mode where inbound/outbound access is via https and
is controlled by the 3PAR Secure Service Agent (SSAgent).
X None of the above. Cancel and Exit
Please enter your selection [X]:
1
NOTE:
Secure Network Mode cannot be enabled through Mixed Connectivity setup.
5.
Type
1
and press
ENTER
to continue with this new installation.
Type of install
Enter Control-C at any time to abort this process
How do you want to configure this SP?
1 ==> Continue with spmob ( new site install )
2 ==> Restore from a backup file ( SP rebuild/replacement )
X None of the above. Cancel and Exit
1
6.
Accept the default SP name (in brackets) by pressing
ENTER
or type an alternate name and
press
ENTER
. The default SP name is the SP serial number. HP recommends that you use the
default SP name.
SP Network Parameters
Enter Control-C at any time to abort this process
Please enter the host name [SPXXXXX]: [enter]
7.
Type the static IP address assigned to the SP and press
ENTER
.
SP Network Parameters
Enter Control-C at any time to abort this process
Please enter the IP address for the public network interface:
<static.IP.address>
8.
Press
ENTER
to accept the default subnet mask, or type an alternate subnet mask for the SP
and press
ENTER
.
Please enter the netmask for this interface [255.255.255.0]:
<subnet.mask.address>
Manually Setting up the Service Processor
51
