HP 11-be0 Series, Руководство по техническому обслуживанию и ремонту

Страница: 43 / 72

Remove the sensor board:
1. Disconnect the sensor board cable from the ZIF connector on the system board (1).
2. Pull the cable out from under the antenna cable that connects to the integrated WLAN module (2).
3. Remove the sensor board from the computer (3).
Reverse this procedure to install the sensor board. Run the camera function test after the repair. For more
information, see Basic camera function test on page 30 .
Power button
To remove the power button, use this procedure and illustration.
Table 5-6 Power button descriptions and part numbers
Description Spare part number
Power button M93501-001
Power button cable M98507-001
Power button bracket M98022-001
Fingerprint reader module M98501-001
Before removing the power button, follow these steps:
1. Prepare the computer for disassembly (see Preparation for disassembly on page 29 ).
2. Remove the display assembly (see Display assembly on page 30 ).
3. Disconnect the battery cable from the system board (see Battery on page 44 ).
Remove the power button:
1. Disconnect the power button cable from the ZIF connector on the system board (1).
2. Remove the two Phillips M2.0 × 3.0 screws (2) that secure the board.
Component replacement procedures 35