Home Repair Manuals Hotpoint WMA32 Dismantle & Repair
Page 48 of 50
Component test (Auto) codes
What you see.
What it means.
Possible solutions.
If just the
END
light
is
on and flashing.
No reading from door
lock circuit..
Door not closed or
interlock related
connection fault
If the
DOOR LOCKED
light
is on and the
END
light
is flashing.
No reading from
pressure switch circuit.
Pressure chamber
blocked, air leak to
P/switch, faulty pressure
switch or related
connections, Water
supply.
If the
SUPER RINSE &
DOOR LOCK
lights
are
on and the
END
light
is
flashing.
Faulty heater or heater
circuit.
Heater, Thermistor, or
associated electrical
connections.
If the
SUPER RINSE
light
is on and the
END
light
is flashing.
Pressure switch not
maintaining circuit after
fill..
Faulty pressure switch,
pressure hose leaking
If the
RINSE HOLD &
DOOR LOCKED
lights
are on and the
END
light
is flashing.
Pressure switch failed to
disconnect after pump
out.
Blocked pressure
chamber, blocked outlet
hose, sump or pump,
faulty pump or pressure
switch, defective wiring
or connections to pump
or switch.
If the
SUPER RINSE,
RINSE HOLD & DOOR
LOCKED
lights are on
and the
END
light
is
flashing.
No motor action during
spin cycle.
Motor, Control Module,
or associated wiring
connections.
If the
SUPER RINSE &
RINSE HOLD
lights are
on and the
END
light is
flashing.
No motor action during
wash cycle.
Motor, Control Module
or associated wiring.
After completion of the test turn the Dial to OFF. The controls will now respond
normally when turned back on.
NOTE:
These light codes are only visible during the auto component test.
