Home Repair Manuals Hotpoint WMA32 Dismantle & Repair
Page 29 of 50
(9) Soap dispenser….
Removal
1.
First do
(1),(2),(3),(5)
2.
Undo retaining clip on dispenser hose on front of container, and pull off.
3.
Remove inlet pipes at rear, (from fill valves).
4.
Unhook from cabinet and lift out.
(9a) Soap dispenser…..
Fitting
1.
Fit locating lug on left side of dispenser into cabinet.
2.
Replace all fill valve hoses (make sure they are
connected to the right nozzles).
3.
Reconnect the dispenser outlet hose to the front of the
container.
4.
Now do
(5a),(3a),(2a),(1a)
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
(10) Pressure switch….
Removal
1.
Remove the top
(1)
2.
Note where the wires go and remove them.
3.
Twist the switch free from its holding bracket. Turn it through 90º (or you may need
to lever it free with a screw driver).
4.
Remove clip on hose and pull it off.
(10a) Pressure switch
…..Fitting
1.
Fit small bore hose and fix with clip.
2.
Push square lug into holding bracket until it clicks.
3.
Refit wires
4.
Replace top
(1a)
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
