horiba APMA-370, Руководство по эксплуатации

Страница: 102 / 107

10 APPENDIX
90
10.3 Unpacking
Unpack the package and check that the following items are included:
10.4 Installation
10.4.1 Contact for installation
10.4.2 Installation environment
The APMA-370 has been designed for uses under general ambient conditions without
assuming any use under special conditions. Install the APMA-370 in a location where the
following conditions are met.

The installation environment of the main power source shall be conform with the
overvoltage category II and the pollution degree 2.

The supply voltage fluctuations shall be

10% of reference voltage.

The power frequency shall be within

1% of reference frequency.

The ambient temperature shall be between 5°C and 40°C without any rapid change of
5°C or more.

The location shall not be exposed to direct sunlight, hot air from a heater, and draft from
an air-conditioner.

It shall be free from significant vibrations and any powerful electric or magnetic field.

The dust level shall be 0.1 mg/m
3
or less.

There shall be no corrosive gas.

The relative humidity shall be 85% or lower.

The altitude shall be 3000 m or less.

A 3-pole power cable set shall be applicable.

The APMA-370 shall be installed indoors.
10.4.3 Installation place

19-inch standard rack

Cut panel

Flat desktop
As illustrated, this instrument requires 222 mm for its vertical space when installed on a 19-
inch rack or cut panel.
It also requires 4 mounting screws and a supporting base.
For the mounting plate and sliding rails, use the optionally available ones.
To install the instrument on a desktop, remove its securing plates located on both sides, which
are used for installation on a rack or cut panel.
For a rack or panel, use a supporting base for the bottom of the APMA-370.
Checklist for items included Check box

Main unit 1 set
□

Instructional materials 1 set
Instruction manual: 1 copy
□
Communication (RS) guide (optional): 1 copy
□

Standard accessories 1 set
Power cable set: 1 piece
□
Filter elements (PA-10L, 24 pieces): 1 box
□
Manufacturer: HORIBA, Ltd.
2 Miyanohigashi, Kisshoin Minami-ku, Kyoto 601-8510 Japan