hopf 4985LAN, Техническое руководство, Страница: 28 / 84

HTTP W
EB
GUI
–
W
EB
B
ROWSER
C
ONFIGURATION
I
NTERFACE
4985LAN Large Matrix Display 4985 - V08.00 28 / 84
hopf
Elektronik GmbH
Nottebohmstr. 41
• D-58511 Lüdenscheid • Tel.: +49 (0)2351 9386-86 • Fax: +49 (0)2351 9386-93 • Internet: http://www.hopf.com • E-Mail: info@hopf.com
5.2.3 Enter or Changing Data
It is necessary to be logged on as one of the users described above in order to enter or change
data.
All changeable data, are saved in Module 8029NTC. For these data the value saving is divided
into two steps.
For a permanent saving the modified value must first be accepted with Apply from the module
and then be stored with Save . Otherwise the modifications get lost after a reboot of the module
or switching the system off.
After an entry with Apply is made, the configured field is marked with a star ' * '. This means
that a value has been entered or changed but not yet been stored in the flash memory.
Meaning of the symbols from left to right:
No. Symbol Description
1 Apply Acceptance of changes and entered data
2 Reload Restoring the saved data
3 Save Fail-save storage of the data in the flash configuration
If the data should only be tested, it is sufficient to accept the changes with Apply .
Changing Network Parameters
Modifications of the network parameters (e.g. IP address) are immediately
effective clicking on
Apply to confirm.
However, the modifications are not permanently saved yet. This requires
to access the WebGUI with the new network parameters again and to
save the data with
Save permanently.
For adopting changes and entering values only the respective buttons in
the WebGUI can be used.