12
power on
1.
press the On/Off button on the Robot to swich it on.
2.
There will be a short musical introduction and the LCD Screen will illuminate for
approximately 5 seconds.
3.
Press the Start / Pause button to start the Robot.
LCD Screen:
The LCD Screen will light up for approximately 5
seconds after a button has been pressed, then it will dim to save
energy.
After 20 seconds of inactivity, the Robot will go into Standby mode. It
can be woken by pressing any key except the On/Off key.
pause
1.
Press the Start/Pause button to stop the operation of the Robot.
2.
Press the Start/Pause button to resume work.
When the Robot is paused, the Cleaning mode can be changed. Press the Pause button
again and the Robot will begin the new cleaning mode.
pause:
There are two other ways to pause the Robot if it is in use:
press any button on the Robot (except On/Off) and it will pause. press
the Start/Pause button to resume.
Lift the Robot up and keep it level, otherwise the collected dust
may fall out of the Robot. Place the Robot back on the floor to
resume.
power off
1.
press the On/Off button to swich it off.
2.
There will be a short musical sound and the LCD Screen will dim.
Batteries:
for optimum Battery performance it is recommended that you keep
your Robots Batteries fully charged.
When the Robot is not in use it should be left connected to the Charging
Station. The Charging Station has an intelligent charging system that
keeps the Batteries fully charged, It also prevents the Batteries from
becoming overcharged.
To avoid accidents, make sure that every person in the room is aware
of the Robots presence. If the Robot becomes lost, place the Robot
on the Charging Station manually.
USinG yOUR ROBOT
